​MACH 3 SETUP

• Here is my setup for Mach3
• Yours, of course can/maybe different
• Check out   Mach3 here
• Check out   UCCNC  (new setup)

* Port - Kernel Speed

* Basic Pin and Port

* Limit Switches / Homing

* Probe and E-Stop

* Output and Enable Screen 

• None selected, everything is off

* Spindle Pulley

• Config - Spindle Pulleys...

This took awhile for me to figure out. Since  Mach3 is setup for PWM for spindle, if you have a Max  Speed set as something very high and call for a lower speed, Mach3 will pulse the motor. This is NOT appropriate for routers and other DC motors which have their own feedback. Set your MAX SPEED to 1000  and in your Gcode call for spindle speed as always 1000 (number doesn't matter as long as they match). Adjust the router or spindle using its own speed control. 

* Homing and Soft Limits

* Mach3 Screen Set

• Mach3 2010 Screen set. Get yours here