Here is the setup. I used contact cement for the "Formica" top on Aspen wood.
Here is the start of the cuts. It is working well and very little splintering. High spindle speed.
More f the sign being cut. I just used clamps to hold the wood down on the table.
I changed bits using my bit changing technique and here are the smaller letters.
I love the font! Again, download fonts from
dafont.com
RECUT OF SMALL PARTS
The very small parts in the letters where broken away when the cutter came by. To fix this I recut just the middle parts and CAed them back on. Looks great
TO RELEASE THE SIGN
I used my table saw and cut the sign out right at the groove of the outer cut. I then used a FLUSH trim bit on the router with my router table to clean it up. Works every time!
