2001-2011 www.CuttingEdgeCNC.com All Rights Reserved Disclaimer
Dremel Mount for the K2 Router
Finally, I have made a Dremel mount for my K2 router.
There are many times I don't think I need to run the Porter Cable router. It is loud and most of my work is done at night (as you can tell :)
Here are the steps in my Dremel Mount.
11-17-2005
Start: 9:30 pm Done: 2:58 am!
UPDATE:
The quality of the Dremel is not up to par. The bearing mount and output shaft
have way to much play. It's "ok" for wood, fine for light plastic and foam but for
aluminum...no no.
I have moved over to the Bouch Colt Trim Router, Click Here 1-10-09
